• Castle E-Z Bead High Temp Red

    Directions: 1. Varies by application. Please consult label. Packaging: 8 oz (#C0809) 12/case
    Details

  • Castle E-Z Bead Low Volatile

    Uses: • Valve Covers • Oil Pans • Thermostat Housing • Water Pumps • Timing Gears • Transmission Pans • Oil Pumps • Axle Covers Directions: 1. Varies by application. Please consult label. Packaging: 8 oz (#C0810) 12/case
    Details

  • Castle Fire One

    Uses: • Automotive • Truck • Marine • Recreational Vehicles • Small Engines Directions: 1. Do not use with glow plugs. 2. Spray one or two short blasts (avoid excessive spray). 3. Crank engine to start. Packaging: 16 oz (#C1604) 12/case
    Details

  • Finger Lakes Graffiti Remover

    Directions: 1. Consult instructions on packaging for various uses. Packaging: 12 oz (#FLSC4512) 12/case 1 gal (#FLSC45128) pail 5 gal (#FLSC4505) pail 15 gal (#FLSC4515) drum 55 gal (#FLSC4555) drum
    Details

  • Castle Hold Tite

    Uses: • All types of gaskets, including metal, cork, rubber, and paper. Directions: 1. See package for specific directions. Packaging: 16 oz (#C1628) 12/case
    Details

  • Castle Hug

    Uses: • Mounting Tires • Removing Tires Directions: 1. Clean rust and foreign matter from area on rim where tire bead will make contact. 2. Hold can 6 to 8 inches from surfaces and spray entire bead. 3. Continue mounting tires. 4. After spraying, clean spray head and extension tube by turning upside down and spraying until only pressure escape. Packaging: 20 oz (#C2009) 12/case
    Details

  • Castle Leak Tracing Powder

    Uses: • Doors • Trucks • Cooling System • Glass • Rear End • Power Steering • Transmission Fluid Directions: 1. Varies by application. Consult product label for specifics. Packaging: 16 oz (#C1619) 12/case
    Details

  • Castle Long Life

    Uses: • Cars • Marine • Golf Carts • Aircraft • Trucks • RV’s • Lawn Equipment Directions: 1. Clean connections with Castle® Corrosion-Off™ . 2. Coat battery connections thoroughly with Castle® Long Life™ Packaging: 3 oz (#C0307) 12/case 16 oz (#C1607) 12/case
    Details

  • Castle Meta-Seal

    Uses: • All Automotive Types • CFC Free • ABS Sensor Safe • Effective from –60° F to 1200° F Directions: 1. Perform complete brake job and thoroughly clean all surfaces. 2. Spray a light mist of Castle® Meta-Seal™ making sure not to saturate. 3. Apply directly to rotors/drums and pads/shoes. 4. Complete assembly and installation. 5. Apply brakes several times at low speed to burnish the Castle® Meta-SeaL™ particles into the friction surfaces. Packaging: 20 oz (#C2093) 12/case
    Details

  • Castle QT

    Uses: • Cars • Trucks • Motorcycles Directions: 1. Spray the back of the pad with an even coat. 2. Allow QT™ to dry until it is sticky, but not wet. 3. DO NOT SPRAY ON THE FACE OF THE PAD Packaging: 16 oz (#C1627) 12/case
    Details

  • Castle Quick Stop

    Uses: • Cars • Buses • Trucks • Any enclosed cooling system Directions: 1. Shake well. 2. Bring engine to operating temperature with the cap off. 3. Pour entire bottle in and allow it to circulate until the leak stops. 4. One bottle is enough for cars; trucks will take proportionally more. Packaging: 12 oz (#C1236) 24/case
    Details

  • Castle Squeal X

    Uses: • Brake pads Directions For New Pads: 1. Shake can well. 2. Spray pad to saturate, let dry, and reapply. 3. Allow pad to dry to touch before assembly (about 10-12 minutes). Directions For Used Pads: 1. Pad must be scuffed to allow penetration of Squeal-X™. 2. Because of glazing of a used pad, Squeal-X™ may not eliminate the squeal entirely. 3. It is necessary to saturate 100% of the pad. Packaging: 6 oz (#C0602) 12/case
    Details

Go to Top